Flexible Stone Installation
Cutting Flexible Stone
Planning clean cuts, openings and edge details without assuming one tool or method fits every flexible stone product.
Overview
Cutting behavior varies with panel composition, backing, thickness and surface texture. Confirm the supplied instructions, test on an offcut and approve the finished edge before cutting production material.
Key steps
01
Measure from verified site dimensions
Coordinate the cut with the setting-out grid, adjoining finishes, tolerances and any trim or sealant zone.
02
Support and mark the panel
Use a clean, stable work surface and a marking method that will not stain or damage the finish.
03
Test the proposed tool
Tool choice may range from a sharp knife to shears or powered cutting equipment, depending on the product. Follow supplier guidance and control dust where relevant.
04
Finish and protect the edge
Check for fraying, chips or exposed backing. Complete the approved edge, trim, sealant or return detail before installation continues.
Openings and penetrations
Avoid forcing panels around uncoordinated services. Mark penetrations accurately, keep required clearances and use the project-approved finishing detail around sockets, pipes, fixtures and access panels.
Frequently asked questions
Can every panel be cut with a knife?
No. The correct tool depends on the exact composition, backing and thickness. Use the supplied instructions and test the proposed method first.
How should visible edges be finished?
The detail may use a clean cut, return, compatible coating, sealant or trim. It should be selected and approved as part of the project mock-up.